Specifications
0DLQWHQDQFH 6HFWLRQ
Figure 4-7. Remove/Install Battery Access Door
5HSODFH0DLQ/RJLF%RDUG
1. Turn the printer Off (2). Disconnect the battery charger.
2. Slide the battery compartment door open and remove the battery.
3. Lay the printer on a flat surface with the back facing up.
4. Remove the two shoulder strap screws indicated in Figure 4-3. Set the shoulder
strap, two shoulder strap sleeves, and two shoulder strap screws aside.
5. Remove the cover mounting screws.
6. Remove the rear cover and set aside.
7. Refer to Figure 4-5. Lift the power supply and main logic boards out enough to clear
the front cover.
8. Refer to Figure 4-6. Hold the power supply board firmly with one hand, and gently
pull the main logic board away from the power supply board.
9. Hold the power supply board firmly with one hand, and gently push the replacement
main logic board 40-pin plug into the power supply board 40-pin receptacle. The
bottom (noncomponent side) of the main logic board faces the battery contacts on
the power supply board.
&DXWLRQ
2EVHUYHSURSHUHOHFWURVWDWLFVDIHW\SUHFDXWLRQVZKHQUHPRYLQJKDQGOLQJDQGUHSODFLQJ
SULQWHGFLUFXLWERDUGV