Specifications

6HFWLRQ 0DLQWHQDQFH
Figure 4-6. Remove/Install Print Mechanism Module
5RXWH%DWWHU\$FFHVV'RRU5HSODFH
1. Turn the printer Off (2). Disconnect the battery charger.
2. Slide the battery compartment door open and remove the battery.
3. Lay the printer on a flat surface with the back facing up.
4. Remove the two shoulder strap screws indicated in Figure 4-3 on page 4-8. Set the
shoulder strap, two shoulder strap sleeves, and two shoulder strap screws aside.
5. Remove the cover mounting screws.
6. Lift the rear cover off and set it aside.
7. Refer to Figure 4-7. Lift the battery access door up and out of the front cover.
8. Insert the new battery access door, ensuring it is in the slot of the front cover with
the flat side facing in.
9. Refer to Figure 4-8. Ensure all harnesses are routed to avoid pinching and screw
posts.
10. Replace the cover and shoulder strap.
11. Install a battery, load the media, and test the unit. Connect a battery charger if
necessary.