Specifications
0DLQWHQDQFH 6HFWLRQ
'LVDVVHPEOH$VVHPEOH3ULQWHU
'LVDVVHPEOH3ULQWHU
1. Turn the printer Off (2). Disconnect the battery charger.
2. Slide the battery compartment door open and remove the battery.
3. Lay the printer on a flat surface with the back of the printer facing up.
4. Remove the two shoulder strap screws indicated in Figure 4-3. Place the shoulder
strap, two shoulder strap sleeves, and two shoulder strap screws to the side.
5. Remove the five cover mounting screws.
6. Lift the rear cover off and place it aside.
7. Refer to Figure 4-4. Disconnect J2 (motor harness) and J1 (printhead harness) from
the power supply board.
8. Refer to Figure 4-5. Grab the print mechanism module by the access door top. Pivot
it upward (the bottom of the print mechanism module is still inside the printer front
cover) and lift straight up. Place the print mechanism module on the antistatic mat.
9. Refer to Figures 4-4 and 4-5. Carefully lift the power supply board and main logic
board out enough to get access to J12 (membrane switch ribbon cable).
10. Remove J12 (membrane switch ribbon cable).
11. Place both boards on the antistatic mat.
12. Refer to Figure 4-7. Lift the battery access door up and out of the front cover.
&DXWLRQ
2EVHUYHSURSHUHOHFWURVWDWLFVDIHW\SUHFDXWLRQVZKHQUHPRYLQJKDQGOLQJDQGUHSODFLQJ
SULQWHGFLUFXLWERDUGV