Specifications
0DLQWHQDQFH 6HFWLRQ
(TXLSPHQW6DIHW\7LSV
R After reviewing each procedure, place a check in the box.
R The AC power plug and IEC 320 connectors on all Zebra printers must bear the
certification mark of at least one international safety organization listed below.
R Unless indicated otherwise, turn the power Off (2) before performing any
maintenance procedures to the printer.
R Always follow proper electrostatic safety precautions when removing, handling,
and replacing all printed circuit boards and integrated circuits.
R Zebra printers comply with international regulations governing radiated emissions
when using fully shielded data cables. Data cables must be fully shielded and
fitted with metal or metalized connector shells. Required Shielded data cables and
connectors prevent radiation and reception of electrical noise. Use of unshielded
data cables may increase radiated emissions above the regulated limits.
R Avoid direct contact with the printhead elements. Dirt and moisture from the skin
can cause corrosion and prematurely shorten the printhead life.
+
R