Specifications
6HFWLRQ 2SHUDWLRQ2YHUYLHZ
6HW&RPPXQLFDWLRQ3DUDPHWHUV
When using the printer’s serial port to transfer data, the printer and the computer must
have identical communication parameter settings.
'HIDXOWYDOXHV
Press and hold FEED until the Error LED flashes once, twice, and then three times.
Release FEED after the LED flashes three times. The baud rate for the printer resets to
9600 baud, 8-bit word length, no parity, 1 stop bit, and the flow control sets to
XON/
XOFF
. The computer’s communication parameters now need to match the default settings
of the printer. Refer to Table 2-1 for a complete listing of Feed Modes.
&XVWRPYDOXHV
If settings different from the default values are needed, send the set communications
(
^SC) ZPL command at 9600 baud via the serial port setup, then reset the computer to the
new values (see the ZPL II Programming Guide for the complete command syntax). To
save the settings permanently, send the
^JUs ZPL II command or recalibrate the printer.
&DOLEUDWH
The printer’s media sensor sensitivity establishes how your printer detects the top of the
label. If you are using die-cut label media, the printer needs to detect the difference
between no media in the printer at all, liner only (indicating the space/gap between labels),
and a label plus liner.
To make these distinctions, the printer shines light through the media and measures the
amount of light making it through the media. In this way, the printer can detect where your
labels begin and end, and when you run out of media.
$PRXQWRIOLJKW
GHWHFWHG
:KDWLWLVGHWHFWLQJ :KDWLWPHDQV
+LJK 1RWKLQJ1RPHGLDLVSUHVHQW
2XWRIPHGLDRUWKHQRWFKJDSEHWZHHQ
ODEHOVLI\RXDUHXVLQJQRWFKHGPHGLD
RUWDJVWRFN
0HGLXP 0HGLDOLQHURQO\
7KHZHEEHWZHHQODEHOVLVGLUHFWO\
XQGHUWKHVHQVRU
/RZ /DEHOSOXVOLQHU $ODEHOLVGLUHFWO\XQGHUWKHVHQVRU
1RWH,I\RXDUHXVLQJQRWFKHGPHGLDRUWDJVWRFNWKHYDOXHVIRU+LJKDQG0HGLXPZLOO
EHLGHQWLFDO7KLVLVEHFDXVHWKHVSDFHEHWZHHQWDJVLVLQGLFDWHGE\DQRWFKRUJDSLQ
WKHPHGLDLQVWHDGRIE\WKHZHEEHWZHHQODEHOV