Specifications
2SHUDWLRQ2YHUYLHZ 6HFWLRQ
Figure 2-10. Media Over Tear Blade
3HHO2II0RGH
1. Refer to Figure 2-6. Raise the media access door by lifting at the notch until it
unhooks from the top cover.
2. Refer to Figure 2-7. Swing open the medis access door to expose the media
compartment.
3. Pivot the top cover to reveal the printhead.
4. Lift the printhead until you feel it lock in place. Do not force the printhead past this
position.
5. Refer to Figure 2-8. Unroll approximately 6 in. (150 mm) of media. Remove and
discard the first label. Thread the end of the media into the printer, just below and
behind the media hangers. Push the end of the media into the printer until it extends
approximately 1 in. (25 mm) beyond the printhead.
6. Separate and hold open the media hangers,
7. Place the media roll onto the media hangers.
8. Refer to Figure 2-7. Release the media hangers so the media locks into the correct
position. Ensure the media is threaded under both media guides.
9. Refer to Figure 2-9. The tear blade should not be installed in the printer. To remove
the tear blade, gently lift the tab on the bar to get it over the door protrusion. Pull the
tear blade out of the printer.
Tear Blade
&DXWLRQ
'RQRWWRXFKWKHSULQWHOHPHQWVWKHSULQWKHDG'LUWDQGPRLVWXUHIURP\RXKDQGVFDQ
SUHPDWXUHO\VKRUWHQWKHSULQWKHDGOLIH