Specifications
6HFWLRQ 2SHUDWLRQ2YHUYLHZ
/RDG6XSSOLHV
Refer to Figure 2-5 for general printer assembly terminology and location for loading
supplies.
7HDU2II0RGH
1. Refer to Figure 2-6. Raise the media access door by lifting at the notch until it
unhooks from the top cover.
2. Refer to Figure 2-7. Swing open the media access door to expose the media
compartment.
3. Pivot the top cover up to reveal the printhead.
4. Lift the printhead until you feel it lock in place. Do not force the printhead past this
position.
5. Refer to Figure 2-8. Unroll approximately 6 in. (150 mm) of media. Thread the end
of the media into the printer, just below and behind the media hangers. Push the end
of the media into the printer until it extends approximately 1 in. (25 mm) beyond the
printhead.
6. Separate and hold open the media hangers.
7. Place the media roll onto the media hangers, ensuring it is tightly wound.
8. Refer to Figure 2-7. Release the media hangers so the media locks into the correct
position. Ensure the media is threaded under both media guides.
9. Refer to Figure 2-9. Install the tear blade into the media access door. Gently lift the
tab on the bar to get it over the door protrusion. Ensure the lip of the bar faces out.
10. Close the printhead and the top cover.
11. Refer to Figure 2-10. Swing up the media access door, ensuring that the media
extends over the tear blade.
12. Lift to hook the top of the media access door over the top cover.
13. Push in the bottom of the media access door to close.
14. Turn the printer On (O) or press FEED if the printer is already on.
&DXWLRQ
'RQRWWRXFKWKHSULQWHOHPHQWVWKHSULQWKHDG'LUWDQGPRLVWXUHIURP\RXKDQGVFDQ
SUHPDWXUHO\VKRUWHQWKHSULQWKHDGOLIH