User guide

69
Printing Configurations
System V Queue Installation
4/19/07 ZebraNet PrintServer II User Guide 45537L-004 Rev. A
System V Queue Installation
Configuring Operating System V Queue for ZebraNet Printing
This section describes the configuration of the printing system on the UNIX operating system.
For clarity and brevity, the following specific names are used to represent general devices or
concepts.
lj4 — The local queue name on the UNIX system to which you want
PSII print jobs
directed.
ZEBRAPRINTER — The host name or IP address of the remote system that is the
PSII
device. For example, to Telnet to the
PSII and invoke the PSII configuration utility, you
would enter:
Telnet ZEBRAPRINTER
A host name is not required for the
PSII — the IP address can be used.
yourqueuename — This is the name of the queue on the ZebraNet and must end with LF1.
Prerequisites
Before you proceed, the following prerequisites must be met:
• The name ZEBRAPRINTER and the IP address assigned to the
PSII are in the /etc/hosts
file on the UNIX system.
• The LPD must be running on the UNIX system.
UNIX Configuration
To configure the UNIX machine so users can spool print jobs to the PCL print
queue on the ZebraNet named ZEBRAPRINTER, complete these steps:
1. Log in to the UNIX machine as root.
2. Type:
lpsystem -t bsd ZEBRAPRINTER
3. Type:
lpadmin -p lj4 -s ZEBRAPRINTER!yourqueuename - I any
4. Type:
accept lj4
5. Type:
enable lj4
6. Try printing by typing the command:
lp -d lj4 [filename]