User guide

Getting Started
Setting Alerts
46
45537L-004 Rev. A ZebraNet PrintServer II User Guide 4/19/07
Setting Alerts
It is important to understand the relationship between the printer and the printer when you are
establishing alerts. Here are the relationships you need to be aware of:
•
Non-ZebraLink-enabled printers — can send alerts on only a specific set of
printer errors that are reported in the IEEE 1284 protocol.
•
ZebraLink-enabled printers — ZebraLink allows for the printer to send alerts not
in the IEEE 1284 protocol.
ZebraNet View
In this section are step-by-steps instructions on how to set up an alert using ZebraNet View.
For information on setting up alerts using ZebraLink, see ZebraLink on page 48.
To set alerts (traps) using ZebraNet View, complete these steps:
1. In the ZebraNet View dialog, from the menu bar select Print Server>Configuration.
2. Click the SNMP Traps tab.
The Printer Traps check boxes are the alerts you can set from ZebraNet View.
3. Enable the alerts (printer traps) you want to set here and click OK.