User guide

Getting Started
Before you begin
38
45537L-004 Rev. A ZebraNet PrintServer II User Guide 4/19/07
Before you begin
printer offers many features, but how you access and work with them is dependent on your
environment. Before you begin, you need to get information from the printer
configuration
label.
To print a printer configuration label, complete these steps:
1. Turn on the printer and let it complete its power-up cycle.
2. Let the printer complete its POST cycle.
3. When the above steps are complete, press Test and hold it in for a few seconds before you
release it.
• On the Z4Mplus and Z6Mplus, the Test button for the internal printer device is a little
button on the back of the printer located under the RJ-45 connector. For more details,
see the illustration under the heading Z4Mplus/Z6Mplus on page 27.
• On any other printer, the Test button on the printer device is a small hole. For more
details, see the illustration under the heading XiII, XiIII, 105SL, and PAX Series
on page 25.
A printer configuration label prints. Your configuration label looks similar to Figure 1
on page 39.
Important • Make sure the printer is turned off (O).