User guide

Installation

Internal PSII

45537L-004 Rev. A ZebraNet PrintServer II User Guide 4/19/07

To install an internal PSII into a Z4Mplus printer, complete these steps:

1. Turn off (O) the printer and disconnect the AC power cord.

2. Lift the media door and find the screw in the upper-middle area of the printer frame.

3. As shown in this illustration, remove the screw and the lock washer:

4. Close the media door.

5. As shown in this illustration to remove the electronics cover, push in and pull up.

Tools • You need these tools to complete this procedure:

 Flat-blade Screwdriver Set  7 mm Nutdriver

Screw

Electronics Cover

Media door

Lock Washer

Printer Back

Cover

Plate

Cover Plate Screws