User`s manual

Troubleshooting
Laminate Problems
980541-003 Rev. A P630i, P640i Card Printer User’s Manual 75
Laminate Problems
Laminate not centered on card
• Vertical offset adjust (mechanical adjustment).
• Horizontal offset: Properties > Device Settings > Printer Adjustment > Laminate
Station Adjust.
Laminate not parallel with card edges
• Skew adjust (mechanical adjustment).
• If using partial width laminate, edge guide not properly installed (one of two
positons).
• Transfer guide not properly installed.
• Laminate patch wrapped around heated roller.
Laminate wrinkling
• Can occur at end of roll. Remove cassette. If nearly out, discard. Install fresh roll.
• If not end-of-roll problem, suspect obstructions in laminate feed path.
Examples of Printhead Failures
White line across length of the card
• The white line is a sign of a blown pixel.
• The adjacent black stripe is a printhead driver problem (components on the head
itself).
• These are independent problems, not necessarily co-located, that may require
replacement of the printhead.
Random occurrences of white (unprinted) spots
• Possible card quality problem. Run IDPrint Lite with graytone.bmp on cards from a
different batch. Check platen surface for specks of debris.
Image not centered on card
• Properties > Device Settings > Printer Adjustment > Horizontal/Vertical Offset.
Image offset on card
• Correct this by increasing horizontal (X) offset, decreasing vertical (Y) offset.