User`s manual

66 P630i, P640i Card Printer User’s Manual 980541-003 Rev. A
Settings and Adjustments
Laminator Station Adjustments
Eject Card Picks up a card, runs it to the flip station, raises it to the laminator infeed, then
ejects it through the laminator. Like Flip Test 1, but done once only, and without flipping.
Flip/Pause Picks up a card, runs it to the flip station, raises it to the laminator infeed, then
holds this position (termed the Insertion Height in the flip station dialog) until the user presses
the PRINT button (at which point the flip carrier descends, and the truck returns the card to the
hopper).
Laminator Station Adjustments
Accurate positioning of the laminate is important for practical and aesthetic reasons. The
laminate must cover the entire image as printed by the P640i at the time of issuance, thus
protecting critical data with a tamper-deterrent film. Additionally, because even the smallest
amount of overhang can compromise the card’s integrity, the patch should be symmetrically
positioned on the card.
To access the Laminate Station Adjustment screen, select Start > Printers (or Printers and
Faxes). Right click on the Zebra P630i or Zebra P640i printer listing. Select Properties >
Device Settings > Printer Adjustment > Laminate Station Adjust
Note • If there is no magnetic stripe on the underside, a full width laminate should be used.