User`s manual

60 P630i, P640i Card Printer User’s Manual 980541-003 Rev. A
Settings and Adjustments
Printing Preferences
Card Setup
From the Card Setup screen, the operator can adjust the following settings:
Image Size Sets the image area for
both front and back of the card (1 inch =
300 pixels).
Cards Specifies the type of card
loaded in the hopper - typically a PVC/
polyester/PVC composite card for
applications where durability is
important.
Ribbon This is the color ribbon
installed in the printer. Choice of two
for most applications: YMCK = 3 color
panels + 1 black panel, and YMCKK =
3 color panels + 2 black panels. For
secure applications a third type of
ribbon is available: YMCUvK (“Uv” is
a panel of ultraviolet responsive resin).
Front/Back Allows you to apply
color or black, or both, to either side of
the card. For example, with a 4-panel
YMCK ribbon the usual arrangement is
YMC (Color) on the front, K (Black) on
the back. If you check both YMC and K
on one side, this sets up a special
condition known as black extraction.
Laminate Allows you to choose
whether laminate will be applied to the
front side, to both sides (P640i Printer
only), or to neither side.
Orientation Allows you to set up the
front and back images, independently,
for landscape or portrait orientation. By
checking the Rotate box, you can also
flip either image upside down.
Note • The following combination is not available: Front landscape and Back portrait.