User`s manual

Settings and Adjustments
Sensors and Interlock Switches
980541-003 Rev. A P630i, P640i Card Printer User’s Manual 53
Ribbon Panel Detect. The current reading of the color ribbon sensor.
Panel Threshold. The current value of the detection threshold for the color ribbon. Above
this value is termed “black,” below this value is termed “not black.”
Laminate Sensors. Reflective sensor that detect the presence of laminate on the transfer
rollers: below threshold = laminate present, above threshold = laminate absent.
Card presence Sensor. The reflective sensor to the right of the card hopper: High = no
card, Low = card present
Printhead Voltage. Should be about 24V.
AC Frequency. 50 or 60 Hz
Assumed AC Voltage. 110V assumed for 60 Hz.
Printhead Temperature. Temperature ceiling 70°C (above that temperature, printing is
stopped until the head cools).
Controller Board Temperature. Should be about 5° above ambient.
Heater Temperature. Temperatures at the top and bottom laminate heater cores.
Logic States. Summarizes all two-state interlocks and photo sensors - a very useful
diagnostic tool