User`s manual

Installation
Installation Procedure
980541-003 Rev. A P630i, P640i Card Printer User’s Manual 27
Step 2. Remove all wrapping from the card deck.
Step 3. Holding the card deck by the sides, hold it vertically against a flat surface such as a
desktop. If the deck is too thick for your hand to hold it comfortably, use about half a
deck at a time.
Step 4. Push the stack back and forth to an angle of about 45° from vertical, so as to separate
all of the cards.
Step 5. Restore the card stack to its original squared-off condition, and place the cards in the
input hopper. The input hopper can hold up to 150 cards.
Caution • Do not touch print surfaces of the cards; this can reduce print quality.
Important • Static charges and edge burrs from the card die-cutting process can render
individual cards stuck together with significant adhesion force. These cards must
be
physically separated from each other before inserting into the Card Feeder; if not separated,
feeding or printing problems may occur.
Note • Cards with a Magnetic Stripe should be loaded with the stripe up and toward the front
of the printer, as shown in the figure below.