User`s manual

26 P630i, P640i Card Printer User’s Manual 980541-003 Rev. A
Installation
Installation Procedure
Step 6. Re-install the Transfer Guide with its top edge above the laminate cutter guide. Pull
back the retaining spring while re-inserting the guide, then release the spring as you
push the guide into position. Press the LAMINATE button to load the Transfer
Roller(s).
Loading Cards
The P630i and P640i Printers use standard ISO CR-80 PVC Composite cards. Do not use
cards with a paper or peel-off / adhesive backing.
• Size 54 x 86 mm (2.125 x 3.375 in) ± 10%
• Thickness .75 mm (.03 in) ± 10%, frequently referred to as “30 mil cards”.
Important • Do not bend cards or touch the print surfaces as this can reduce print quality. The
surface of the cards must remain clean and dust free. Always store cards in an enclosed
container. Ideally, use cards as soon as possible.
Step 1. Open the Card Feeder Cover.
Important • Improper replacement of the Transfer Guide can cause laminate skewing
and misfeeding. Be sure the Transfer Toggle is set to RUN. Take care to avoid damaging
the Transfer Roller ribs when replacing the Transfer Guide.