User`s manual

Installation
Installation Procedure
980541-003 Rev. A P630i, P640i Card Printer User’s Manual 25
Step 2. Close the main cover. If there was a laminate error before you replaced the cassette,
laminate will automatically feed from the just-loaded cassette, followed by a cutting
action to free a “patch” of laminate onto the transfer roller. If laminate does not feed
automatically, press the LAMINATE button on the printer control panel.
Clearing the Laminate Channels
If your scissor cuts were neat enough to pass for machine-made cuts, continue with printing
cards. If not, don’t waste a print cycle. Instead, remove the hand-cut patch(es) from the
Transfer Roller(s) as follows.
Removal of the Transfer Guide gives access to the Transfer Roller
Step 1. Push the Retaining Spring to the left; pull the Transfer Guide straight out toward you.
Step 2. Remove and discard the laminate patch on the Transfer Roller. Never re-use!
Step 3. Turn the Transfer Toggle to the OPEN position.
Step 4. Remove any laminate between the Transfer Rollers.
Step 5. Return the Transfer Toggle to the RUN position.
Note • Clearing procedures for the upper and lower laminate channels are similar. The upper
channel is shown here.
OPEN
RUN
Transfer
Guides
Retaining
Springs
Transfer Toggle
(Shown in Normal
RUN Position; Set
to OPEN Only
When Specified)