User`s manual

22 P630i, P640i Card Printer User’s Manual 980541-003 Rev. A
Installation
Installation Procedure
Step 7. Holding the cassette with the white roller up and pointing to your left, rotate the core
counter-clockwise to reel in the laminate. Stop when the end of the laminate is even
with the edge of the lips of the cassette.
Using Partial-Width Laminate
Note • Since partial-width laminates are only used for the back (i.e., lower) surface of the
card, this section only applies to the P640i Printer.
Laminate come in three widths:
“Full-Width” laminate is 2 in (51 mm) wide. Full-width laminate is used on the front (i.e.,
upper) or back (i.e., lower) surface of the card.
“Partial-Width” laminate is available in two widths:
• 1.66 in (42mm) wide laminate is used for cards with a writable signature panel.
• 1.33 in (33 mm) wide laminate is used for cards with a magnetic stripe
If there is no signature panel or magnetic stripe on the back of the card, full-width laminate
would generally be used.
Important • Check for overhang any time the cassette latch is opened or the cassette is
removed.