User`s manual

14 P630i, P640i Card Printer User’s Manual 980541-003 Rev. A
Installation
Installation Procedure
Step 4. Route the Ribbon as shown in the figure below. The Ribbon Supply Spindle is free-
wheeling; pull ribbon off it as needed. If the tape removed from the new ribbon in
step 2 is undamaged, use it to attach the end of the ribbon to the Take-Up Spool;
otherwise use other adhesive-backed tape.
Important • When the end of the ribbon is attached to the Take-Up Spool, any slack in the
ribbon can be taken up by rotating the Ribbon Supply Spool; do not try to turn the Take-Up
Spool