User`s manual

22 P110i & P110m Card Printer User’s Manual 980515-001 Rev. C
Printer Setup
4. Holding the card deck by the sides, hold it vertically against a flat surface such as a
desktop. If the deck is too thick for your hand to hold it comfortably, use about half a deck
at a time.
5. Push the stack back and forth to an angle of about 45° from vertical, so as to separate all of
the cards.
6. Restore the card stack to its original squared-off condition, and place the cards in the input
hopper.
7. Place stack of up to 100 cards into card feeder and close the card feeder cover. When card
feeder cover is closed, the card guide locking mechanism will automatically be released.
Note • Static charges and edge burrs from the card die-cutting process can render individual
cards stuck together with significant adhesion force. These cards must be
physically
separated from each other before inserting into the feeder; if not separated, feeding or
printing problems may occur.