User`s manual

• - Sect.1-7 • Introduction •RMAN-MZS-002 rev. A
INTRODUCTION TO LABEL VISTA
Label Vista is a program running under the Windows™ environment that allows
users to design labels which can be printed on the full range of Zebra mobile
printers.
Label Vista also provides a powerful set of diagnostics tools which use familiar
Windows “point and click” routines. These tools can be reached under the Printer
selection on the Label Vista menu bar. It is recommended that the Label Vista
documentation package be consulted for a more detailed description of the printer
diagnostics available in Label Vista.
Equipment Required For Label Vista
1. An IBM-PC Compatible with:
• Pentium CPU
• 256 MB RAM
• 1.44 MB Floppy Drive
• 1 GB Hard Drive
• CD-ROM drive
• SVGA 14” monitor and SVGA card
• 2 Serial Ports, 1 Parallel Port
• A USB port
• Windows 95/98 or NT
2. USB Interface Cable part number AT17010-1 or a Zebra approved equivalent.
3. Digital Multimeter (Fluke 77 or similar) with a minimum impedance >100 KΩ
4. Spare batteries, charger and test media specific to the printer. Refer to the table
in the “Tools and Supplies” topic in Section 2 of this manual.
Starting Label Vista
1. Plug the USB cable into a USB port on your PC
2. Plug the other end of the interface cable into the printer’s USB port.
3. Start the Label Vista program by either clicking on the Label Vista shortcut on
your desk top, or using the “Start” button.
4. Use Label Vista’s extensive built-in Help topics for instructions on using its many
design, editing and diagnostic features.