User`s manual

NOTE FOR MZ 220 ONLY: If you have secured the drive gears with a piece of tape when removing

the printer frame, remove it before re-assembling the printer frame.

4 Secure the printer frame to the lower cover with two self-tapping screws.

NOTE: Ensure the antenna cable is routed so that it will not become pinched when the upper

cover is reassembled.

5. Install the latch release button on the printhead assembly by dropping the

grooved sections on the side of the latch release over the pins in the Printhead.

The latch release button will “ﬂoat” on the supports projecting from the

printhead assembly.

NOTE: The “ﬂat “ side of the latch release button faces the Printhead.

Install the Upper Housing

1. Assemble the upper housing to the printer, capturing the latch release button.

NOTE: If you have disconnected the antenna coax cable from the antenna, reconnect it at this

time.

2. Secure the upper housing with (4) self-tapping screws. Two screws are

inside the media compartment and the remaining two are on the underside of

the printer near the control switches.

It is recommended that the complete unit test procedure be performed whenever a radio

assembly has been replaced.

• Sect.2-33 • RMAN-MZS-002 • MZ Series Repair Procedures