User`s manual

Install the Replacement Gears

1. Slide the white replacement Compound Gear onto the shaft nearest the Motor.

The large diameter gear must be closest to the printer frame and will mesh with

the Motor’s pinion gear.

2. Slide the black Compound Gear onto the middle shaft. The large diameter gear

will face the printer frame and will mesh with the white Gear.

3. Slide the remaining gear on the last shaft on the printer frame.

4. Assemble the new Gear Cover to the Printer Frame with the supplied self-tapping

Screw.

Install the Printer Frame Assembly

1. Assemble the printer frame assembly back into the lower housing.

2 Secure the printer frame to the lower cover with two self-tapping screws.

3. Install the latch release button on the Printhead Assembly by dropping the

grooved sections on the side of the latch release over the pins in the Printhead.

The latch release button will “ﬂoat” on the supports projecting from the

Printhead Assembly.

NOTE: The “ﬂat “ side of the latch release button faces the Printhead.

Install the Upper Housing

1. Assemble the upper housing to the printer, capturing the latch release button.

2. Secure the upper housing with (4) self-tapping screws. Two screws are inside the

media compartment and the remaining two are on the underside of the printer

near the control switches.

It is recommended that the complete unit test procedure be performed whenever a motor has

been replaced.

RMAN-MZS-002 • MZ Series Repair Procedures • Sect.2-30 •