User`s manual

Remove the Motor
1. Remove the screw securing the Motor to the printer frame.
2. Rotate the motor counterclockwise (when facing the outside of the printer frame)
until the mounting ear of the motor is free of its retaining feature on the printer
frame.
3. Pull the motor free of the printer frame. Unplug the motor from the main logic
board.
Replace the Motor
1. Plug the connector from the replacement Motor into the main logic board.
2. Assemble the replacement Motor to the printer frame.
NOTE: Ensure the wires of the Motor emerge from the l.h. side as you face the pinion gear end of
the motor.
3. Rotate the Motor clockwise as shown until the mounting ear of the Motor
engages with its retaining feature on the printer frame, and the mounting hole on
the other mounting ear lines up with the insert on the printer frame.
4. Secure the Motor with the supplied screw.
Remove the Gears
1. If you are replacing the drive Gears with the ones supplied with this repair kit,
remove the Gear Cover by removing the securing screw and pulling the cover
off.
2. Remove the (3) old gears by sliding them off their shafts.
continued
• Sect.2-29 • RMAN-MZS-002 • MZ Series Repair Procedures
Motor
Motor Connector
White Compound
Gear
Black Compound
Gear
Rotate in this
direction to install
motor
Gear Cover
Black Gear