User guide

7
MZ™Series
Quick Start Guide
Area Method Interval
Printhead
Use a Zebra cleaning pen or a 70% isopropyl alcohol solution on a
cotton swab to clean the print elements from end to end (the print
elements are located in the thin gray line on the printhead).
After every five rolls of
media (or more often,
if needed)
Platen
Rotate the platen roller and clean it thoroughly with a Zebra
cleaning pen or a 70% isopropyl alcohol solution and a cotton
swab.
Tear bar
Clean thoroughly with a Zebra cleaning pen or a 70% isopropyl
alcohol solution and a cotton swab.
Exterior Water dampened cloth As needed
Media
Compartment
Interior & Media
Sensors
Brush/air blow.
After every five rolls of
media (or more often,
if needed)
Cleaning the Printer
 Caution•Toavoidpossiblepersonalinjuryordamagetothe
Printer,neverinsertanypointedorsharpobjectsintothePrinter.
 Note•Twelvepacksofapprovedcleaningpensareavailablefrom
Zebra as p/n AN11209-1.
Introduction
Getting Started
Using the
Printer
Troubleshooting
Accessories
Contact Us
Tear Bar
Printhead
Elements
Platen Surface
Media
Compartment
Media
Sensors