User guide

2
MZ™ Series Quick Start Guide
Installing the Battery
Batteries are shipped uncharged. Remove any
protective packaging from a new battery pack, install it
in the printer and charge completely prior to initial use.
Section Continues
Removing the Battery
1. Use a coin to
rotate the Battery
Compartment lock
1
/
4
turn as shown.
2. Remove the Battery
Compartment Cover
Always release the locking barb before unplugging the
battery connector. Do not attempt to remove the connector
by force, or by using pliers, etc. as this could cause damage
to the printer’s CPU assembly.
Introduction
Getting Started
Using the
Printer
Troubleshooting
Accessories
Contact Us
1. Use a coin to
rotate the Battery
Compartment lock
1
/
4
turn as shown.
2. Remove the Battery
Compartment Cover
3. Plug the Battery
Pack connector into
the Printer.
Battery Pack
Note location of label
4. Re-install the Battery Com-
partment Cover and rotate
the lock back
1
/
4
turn to lock it
in place .
Ensure battery leads are not pinched prior to replacing
battery cover.
Battery Pack Connector
Squeeze lock to release.
Allow old battery pack to
drop out of the printer