User guide
11
MZ™Series
Quick Start Guide
Belt Clip
(Standard on all printers)
To use: hook the clip over your belt and ensure that the clip is
securely attached to the belt. The belt clip will pivot to allow
you to move freely while wearing the Printer.
Accessories
Adjustable Shoulder Strap
(Available as an Accessory Kit)
Refer to figure below. Secure each end of the shoulder strap by
looping through the slots on the belt clip and securing with the
buckle.
Oncetheshoulderstrapissecured,holdthebuckleandadjustthe
strap as shown until you achieve the desired length.
Introduction
Getting Started
Using the
Printer
Troubleshooting
Accessories
Contact Us
Clip Printer to
belt
Thread the free end of the shoulder
strap through one of the slots on
the belt clip
Thread the free end of the shoulder
strap through the buckle and pull
tight to adjust.
Do the same procedure on the
other end of the strap in the
remaining slot on the belt clip.
Hold Buckle
Pull Strap here
to lengthen
Pull Strap here
to shorten