User guide

3
MZ™ Series Quick Start Guide
Charging the Battery
The printer may be used while charging the battery. However, prolonged use of the printer while charging will greatly increase charge
times.
Preparing the Charger Power Supply
Using the Charger Power Supply
Remove the power supply from its box. Remove and discard the shipping ring
from the mains receptacle cavity.
Verify that the mains adapter shipped with your Printer is the correct one for
your region.
Install the mains adapter into the Power Supply by hooking the top edge into the
mains receptacle cavity, and rotating it until it snaps into place.
Shipping Ring
Remove and discard
Section Continues
Introduction
Getting Started
Using the
Printer
Troubleshooting
Accessories
Contact Us
Mains Adapter
MZ Series Charger Power Supply p/n AT17947-2
110-240 VAC 50-60 Hz 0.6A Input;
12 VDC 1.25 A output
Plug into appropriate AC receptacle.
Plug into printer
Charger Jack