User guide
Table Of Contents
- Printer Operation
- Maintenance and Troubleshooting
- Appendix A – Printer Configuration
- Appendix B – Using the Serial/USB Interface
- Appendix C – Using the IrDA® Interface
- Appendix D – Using the Bluetooth® Interface
- Appendix E – Using the Wi-Fi® Interface
- Appendix F – Additional Setup Features
- Appendix G – Printer Setup Menu Summary
- Appendix H – Mobile Setup Utility
- Appendix I – Control Panel Setup
- Appendix J - Power Considerations
- Appendix K – Print & Font Samples
- Appendix L – Specifications
- Glossary of Terms
Appendix I – Control Panel Setup
Example: Changing the Serial Interface Baud Rate
This example shows the steps required to change the serial baud rate from 57600 to 38400.
1. Make sure the printer is turned off.
52
2. Hold the
Enter Button and turn the printer on with the Power
Button. Hold the
Enter Button until “Menus Active” is displayed.
Menus Active
3. After releasing the Enter Button, the printer will display “Entering
Setup Menus” and will then proceed to “Interface” and will display the
currently active interface on the bottom line.
Note: If “Serial” is not displayed, please refer to “Appendix B – Using
the Serial/USB Interface” for instructions on how to make Serial
the currently selected interface.
Entering
Setup Menus
INTERFACE
Serial
4. Press the Enter Button to enter “Interface”, and continue to press the
Enter Button until “Baud Rate: 57600” is displayed.
Emulation
Dascom
Baud Rate
57600*
5. Press the Increment Button three times to advance the value to
“38400”.
Baud Rate
9600
Baud Rate
19200
Baud Rate
38400
6. Press the Advance Button until “Exit Setup Save Changes” is
displayed.
Exit Setup
Save Changes
7. Press the Enter Button to exit Setup. The printer will indicate that it is
saving the changes, will perform an internal reset, and then be ready for
use with the new values that were entered.
Exiting Menus
Saving Changes