User guide
Table Of Contents
- Printer Operation
- Maintenance and Troubleshooting
- Appendix A – Printer Configuration
- Appendix B – Using the Serial/USB Interface
- Appendix C – Using the IrDA® Interface
- Appendix D – Using the Bluetooth® Interface
- Appendix E – Using the Wi-Fi® Interface
- Appendix F – Additional Setup Features
- Appendix G – Printer Setup Menu Summary
- Appendix H – Mobile Setup Utility
- Appendix I – Control Panel Setup
- Appendix J - Power Considerations
- Appendix K – Print & Font Samples
- Appendix L – Specifications
- Glossary of Terms
Appendix E – Using the Wi-Fi
®
Interface
INTERFACE MENU – Wi-Fi Selected
Setup Method
Menu Item Values Default Value
Control
Panel
Setup
Utility
Web
Page
Emulation Printek, O’Neil, ZPL-II, Mt3, CPCL,
MPL, IPL, ESim, Hex Dump
CPCL
9 9
Pass Through Mode On, Off Off
9 9 9
SSID Any
9 9
Type Access Point, Ad Hoc Ad Hoc
9 9
Channel 1
9 9
Encryption WEP 64, WEP 128, WPA, Open Open
9 9
Authentication Open PSK, Shared PSK, PSK, Leap Open PSK
9 9
Auth Protocol PAP, MS-CHAP v2 PAP
9 9
Use WEP Key # 1
9 9
IP Method DHCP
9 9
Address 192.0.0.192
9 9
Subnet 255.255.255.0
9 9
Gateway 192.0.0.1
9 9
Printer Server Port 8023
9 9
Advanced Features Contact Dascom Technical Support
9
Emulation
Possible Values: Printek, O’Neil, ZPL-II, Mt3, CPCL* may be used by a host application program to control
the various capabilities of the printer. The printer will only respond to commands valid for
the currently selected emulation. For more information, please refer to the DP-5XX
Programmer’s Manual.
Note: After pressing the
Enter Button to move from Emulation to WLAN Type, the printer will pause
and display “Waiting for Wi-Fi” while reading the current configuration from the Bluetooth interface
module.
Radio Pass Through
Possible Values: On, Off*
This item will allow direct access to the printer’s Wi-Fi module using a Telnet session. Contact Dascom
Technical Support for a list of commands.
39