User guide

Appendix C – Using the IrDA
®
Interface
3. To select the IrDA interface, press and hold the
Enter Button until the following is displayed.
Interface Now
IrDA
4. To obtain the current parameter settings for the IrDA interface, press and hold the
Enter Button until
the following is displayed. You may ignore any information on the bottom line.
Printing Setup:
----------------
IrDA
®
Interface Configuration
When using IrDA
®
communications, the only interface setting that is required is the printer emulation language
as indicated below.
The emulation may be configured using either the Mobile Setup Utility or the printer’s internal Control Panel
Setup feature as described in
Appendix I. Before using the Mobile Setup Utility, please read the following note
and then refer to
Appendix H.
Note: In order to use the Mobile Setup Utility, communications must first be established between the host
device running the utility and the printer. This may require that you first use the Control Panel Setup
to establish communications and then use the Mobile Setup Utility for final configuration or to
configure items in other menus.
INTERFACE MENU – IrDA Selected
Setup Method
Menu Item Values Default Value
Control
Panel
Setup
Utility
Emulation Printek, Oneil, ZPL-II, Mt3, CPCL,
MPL, IPL, ESim, HexDump
CPCL
9 9
Emulation
Possible Values: Printek, O’Neil, ZPL-II, Mt3, CPCL*, MPL, IPL, ESim, Hex Dump
This item sets the printer control language that may be used by a host application program to control the various
capabilities of the printer. The printer will only respond to commands valid for the currently selected
emulation. For more information, please refer to the DP-5XX Programmer’s Manual.
32