Installation Guide
Table Of Contents
- Terms of Use
- Contents
- About This Document
- Hardware Specifications and Installation
- Lozier® Shelves
- MB1000 Beacon: MPACT-T1B20-000-WR
- MB1000 Beacon: MPACT-T1B10-000-WR
- MPACT-MB2000-01-WR, MPACT-MB1000-01-WR, MPACT-MB2001-01-WR, MPACT-SB2000-01-WR
- USB Beacon: MPACT-MB3000-01-WR
- Beacon Part Numbers: MPACT-MB4000-01-WR and MPACT-MB4001-01-WR
- Beacon: MPACT-MB1000-01-WR and MPACT-SB1100-01-WR
- Fixed IoT Bridge (hub): MB5000-01-WR
- Mobile IoT Bridge (badge): MB6000-01-WR
- Cradle Charger: MPACT-MB6000-CHRGR
- Troubleshooting
Hardware Specifications and Installation
33
Figure 37 Routing Power Cable
Battery Charging Guidelines
Failure to follow these guidelines may result in fire, explosion or other hazard.
• The MB6000-CHRGR in intended for use with the MB6000-01-WR only and should not be used with
other products or batteries.
• The area in which the units are charged should be clear of debris and combustible materials or
chemicals. Particular care should be taken when charging in a non commercial environment.
• To charge the battery, the battery and charger temperatures must be between 32–104°F (0–40°C).
• Do not use incompatible batteries and chargers. Use of an incompatible battery or charger may present
a risk of fire, explosion, leakage or other hazard. If you have any questions about the compatibility of a
battery or a charger, contact Zebra Support.
• Do not disassemble, open, crush, bend or deform, puncture or shred the badge or charger
• Impact from dropping the badge and charger on a hard surface could cause the battery to overheat.
• Do not short circuit a battery or allow metallic or conductive objects to contact the battery terminals.
• Do not modify, re-manufacture, insert foreign objects into the battery, immerse or expose to water or
other liquids, or expose to fire, explosion or other hazard.
• Do not leave or store the equipment in or near areas that might get very hot, such as in a parked vehicle
or near a radiator or other heat source. Do not place battery into a microwave oven or dryer
• If you suspect damage to your equipment or battery, contact Zebra Support to arrange for inspection.
• See Battery Safety Information in section 2.11.1.