Installation Guide
Table Of Contents
- Terms of Use
- Contents
- About This Document
- Hardware Specifications and Installation
- Lozier® Shelves
- MB1000 Beacon: MPACT-T1B20-000-WR
- MB1000 Beacon: MPACT-T1B10-000-WR
- MPACT-MB2000-01-WR, MPACT-MB1000-01-WR, MPACT-MB2001-01-WR, MPACT-SB2000-01-WR
- USB Beacon: MPACT-MB3000-01-WR
- Beacon Part Numbers: MPACT-MB4000-01-WR and MPACT-MB4001-01-WR
- Beacon: MPACT-MB1000-01-WR and MPACT-SB1100-01-WR
- Fixed IoT Bridge (hub): MB5000-01-WR
- Mobile IoT Bridge (badge): MB6000-01-WR
- Cradle Charger: MPACT-MB6000-CHRGR
- Troubleshooting
Hardware Specifications and Installation
32
While in the charger, the badge could conduct a software or configuration update if required and a status
update.
Installation
The charger can be wall mounted using the screw holes on the back or placed on a flat surface. The screw
holes are 5.36 inches (136 mm) apart. When selecting a deployment location, ensure the power adapter
cables reach from the electrical outlet to the charger. The charger and its power adapter must be deployed
in a well ventilated location. The charger and power adapter should have a 1-inch clearance on each side
from surrounding objects. It must only be deployed indoors, in a dry area free from spills or potential
contamination. The temperature should be between 60–80°F (15–27°C).
The charger is designed so DC power cable can be installed from the rear of the charger housing without
removing the base. The cable and connector do not interfere with the base lying flat on any surface. The
DC cord snakes through strain relief features in the housing to prevent accidental disconnects. The
external power adapter DC cable terminates with a right-angle connector at the charger interface.
Specification Value
Charger Capacity 1–10 badges simultaneously
Voltage 5Vdc ± 5%
Current Each Badge requires 900 mA during charging, total 5Vdc power is 10 Amps
Power
Consumption
50–60 Watts
Power Supply External 12 Vdc, 5 Amps max, 60 watts total, enclosed power supply
Power Cord AC power cord connecting external power supply to AC power
Power Supply
Connector
Barrel connector (2.5mm outside diameter). The plastic enclosure has built-in
strain relief to prevent accidental disconnects.
Power Indicator All Badges within the charger platform have LEDs indicating charging state
Temperature 32–104°F (0–40°C) (operating), -40–158°F (-40–70°C) (storage)
Humidity 5–95% RH (operating) 85% RH (storage)
Altitude 8,000 ft @ 82.4°F (28°C) (operating), 30,000 ft @ 53.6°F (12°C) (storage)