Installation Guide

Hardware Specifications and Installation
29
Shutdown the badge - Press and hold button 2 between 20 and 30 seconds, then release. LEDs will
blink 5 times to confirm the badge shutdown. Use this process when brining a deployed badge
off-line.
3. For additional information about the configuration process and JSON files, contact your product line
manager.
Cleaning
Use alcohol to clean this product. When using sodium hypochlorite (bleach) based disinfectants to clean
the product, always follow the manufacturers recommended instructions regarding the use of gloves during
application and to remove the residue afterwards with a damp cloth to avoid prolonged skin contact while
handling the scanner. Please note that due to the powerful oxidizing nature of sodium hypochlorite the
metal surfaces on the product are prone to oxidation (corrosion) when exposed to this disinfectant in the
liquid form and should be removed promptly after cleaning with a damp cloth.
NOTE: Use pre-moistened wipes to clean the unit. Do not allow liquid cleaners to pool or remain on the
unit.
Cleaning frequency is discretionary in respect to the environments the MB6000-01-WR and the
MB6000-CHRGR are deployed. They may be cleaned as frequently as required.
Battery Safety Precautions
Usage
Misusing the battery may cause the battery to get hot, rupture or ignite causing serious injury. Be sure to
follow the safety rules listed below:
Read and follow all guidelines in the Regulatory Guide included with every shipment:
Do not open or attempt to remove the battery from the MB6000-01-WR housing
Do not place the battery in fire or heat the battery.
Do not install the battery backwards so that the polarity is reversed.
Do not connect the battery’s positive terminal and the negative terminal to each other with any metal or
conductive object (such as a wire).
Do not carry or store batteries together with necklaces, hairpins or other metal objects
Do not pierce a battery with nails, strike the battery with a hammer, step on the battery or subject it to
strong impacts or shocks.
Do not apply solder to the battery
Do not expose the battery to water or allow the battery to get wet or exposed to moisture.
Do not disassemble or modify the battery. The battery contains safety and protection devices which, if
damaged, may cause the battery to generate heat, rupture or ignite.
Do not place the battery on or near fires, stoves or other high temperature locations.
Do not place the battery in direct sunlight for prolonged periods.
Do not store the battery or use the unit in a car. Doing so may cause the battery to generate heat,
rupture or ignite.
Device is not for use by children.
When the battery is worn out, insulate the terminals with adhesive tape or similar material before
disposal.