Installation Guide
Table Of Contents
- Terms of Use
- Contents
- About This Document
- Hardware Specifications and Installation
- Lozier® Shelves
- MB1000 Beacon: MPACT-T1B20-000-WR
- MB1000 Beacon: MPACT-T1B10-000-WR
- MPACT-MB2000-01-WR, MPACT-MB1000-01-WR, MPACT-MB2001-01-WR, MPACT-SB2000-01-WR
- USB Beacon: MPACT-MB3000-01-WR
- Beacon Part Numbers: MPACT-MB4000-01-WR and MPACT-MB4001-01-WR
- Beacon: MPACT-MB1000-01-WR and MPACT-SB1100-01-WR
- Fixed IoT Bridge (hub): MB5000-01-WR
- Mobile IoT Bridge (badge): MB6000-01-WR
- Cradle Charger: MPACT-MB6000-CHRGR
- Troubleshooting
Hardware Specifications and Installation
28
Figure 34 IoT Bootstrapping
Figure 35 IoT Bridge Operation as Deployed
To provide the hub its initial and scanning configurations:
1. Initialize the hub. The hub scans for its initial configuration. The hub has a fixed SSID of mpact_init and
a preset WPA2 password of mpact123. When unable to provision itself the hub connects to
192.168.1.100 (a fixed location) and downloads its initial configuration file (badge_config.json).
NOTE: The 192.168.1.100 location must be reachable from the hub’s connected Access Point mpact_init
SSID to receive its required badge_config.json file.
The hub obtains its badge_config.json file and self-configures its initial configuration. Once completed,
the hub connects to its posting server to obtain its scanning configuration. The scanning configuration is
required to define the hub’s scan interval and beacon profile determining how beacon data is
forwarded, based on the beacon’s UUID and Major values, and posted to the server for administration.
2. If you encounter issues with the setup of the hub, there’s several file restoration options available.
• Reboot the badge - Press and hold button 2 (see Figure 33) between 10–20 seconds, then release.
LED 1 will blink slowly twice to confirm. Any in-process configuration activity will need to be
re-started.
• Erase to factory default configuration and reboot - Press and hold button 2 between 30–40 seconds,
then release. LED 1 will blink slowly twice to confirm. The deletion of the initial configuration could
be warranted if the configuration was not successfully applied on the first attempt. Once reverted to
factory configuration, the initial config and scanning config can be re-applied.