Installation Guide
Table Of Contents
- Terms of Use
- Contents
- About This Document
- Hardware Specifications and Installation
- Lozier® Shelves
- MB1000 Beacon: MPACT-T1B20-000-WR
- MB1000 Beacon: MPACT-T1B10-000-WR
- MPACT-MB2000-01-WR, MPACT-MB1000-01-WR, MPACT-MB2001-01-WR, MPACT-SB2000-01-WR
- USB Beacon: MPACT-MB3000-01-WR
- Beacon Part Numbers: MPACT-MB4000-01-WR and MPACT-MB4001-01-WR
- Beacon: MPACT-MB1000-01-WR and MPACT-SB1100-01-WR
- Fixed IoT Bridge (hub): MB5000-01-WR
- Mobile IoT Bridge (badge): MB6000-01-WR
- Cradle Charger: MPACT-MB6000-CHRGR
- Troubleshooting
Hardware Specifications and Installation
26
The badge and hub product are tested and receive EMC regulatory certifications on a per country basis.
Zebra provides a list of all approved countries where the units are able to be sold to end-customers and
used by end-users. By design, the operation of the units is controlled by firmware in accordance with the
approved regulatory domains (i.e. approved countries). The initial production release product (Rev. A) has
a default country domain with somewhat reduced RF performance to ensure compliance with most
domains globally. The units will initially operate in this “world safe” default scanning for Wi-Fi access point
802.11d country information. The units will either set the country operation to the 802.11d information (if an
approved country), or if not and approved country, the units will continue to operate in the “world safe”
default mode. The unit never allows use of 2.4 GHz channels 12 and 13.
The badge is a wearable beacon that’s clipped to one’s body, typically in the mid section or belt area.
The badge needs to be attached to a person in a manner directing RF radiation away from the body. The
RF antennas radiate out from one side of the badge. A MB6000-01-WR badge is designed to enhance
personal safety.
Figure 32 Correct Clothing Mount
NOTE: The clip portion of the badge is replaceable. Refer to Part No. MB6000-01-ACC when ordering a
replacement clip for a MB6000-01-WR model badge.
To mount a MB6000-01-WR model badge:
1. Clip an initialized badge to your midsection or belt area
2. If you encounter issues with the setup of the badge, there’s several file restoration options available.