Installation Guide

Hardware Specifications and Installation
19
To mount a MPACT-MB1000-01-WR or MPACT-SB1100-01-WR model beacon:
1. Peel the tape from the adhesive pads on the rear of the asset beacon (as shown below) and press the
unit to the mounting surface.
Figure 23 Adhesive Tape
NOTE: If the surface is clean and smooth, use the tape to mount the beacon. However, if the surface is
wood, brick or other non-smooth surface use appropriately sized screws for mounting (not included).
NOTE: Ensure the beacon is positioned correctly, Once the beacon is mounted on the bracket it will be
difficult to remove.
If the beacon is moved, the adhesive pads must be replaced.
Initialize the unit per the operating instruction.
Mounting using Tape
1. Clean the surface with a 50:50 mixture of isopropyl alcohol (IPA) and water before applying tape.
Some surfaces may require additional preparation such as the following:
Use degreasers or solvent-based cleaner to remove heavy oil or grease from a surface followed by
cleaning with IPA/water
Scrape the surface, followed by cleaning with IPA/water to remove heavy dirt or oxidation and
increases surface area to improve adhesion.
Prime the surface to improve initial and ultimate adhesion to many materials such as plastics and
paints.
Seal porous and fibered materials such as wood, particleboard, and concrete to provide a unified
surface. Mount with two No. 6 gauge or M3.5 screws (not included).
2. Peel the plastic off from the tape.
3. Press the backside of the Outdoor style beacon firmly to a smooth, flat and clean mounting surface.