Installation Guide
Table Of Contents
- Terms of Use
- Contents
- About This Document
- Hardware Specifications and Installation
- LozierĀ® Shelves
- MB1000 Beacon: MPACT-T1B20-000-WR
- MB1000 Beacon: MPACT-T1B10-000-WR
- MPACT-MB2000-01-WR, MPACT-MB1000-01-WR, MPACT-MB2001-01-WR, MPACT-SB2000-01-WR
- USB Beacon: MPACT-MB3000-01-WR
- Beacon Part Numbers: MPACT-MB4000-01-WR and MPACT-MB4001-01-WR
- Beacon: MPACT-MB1000-01-WR and MPACT-SB1100-01-WR
- Fixed IoT Bridge (hub): MB5000-01-WR
- Mobile IoT Bridge (badge): MB6000-01-WR
- Cradle Charger: MPACT-MB6000-CHRGR
- Troubleshooting
Hardware Specifications and Installation
16
Figure 17 Back of Outdoor Style Beacon
Figure 18 Top of Outdoor Style Beacon
NOTE: On MPACT-MB4000-01-WR model outdoor beacons, the large red antenna pattern indicates that
the antenna is pointing down.
NOTE: When installing numerous beacons, group beacons by category and activate them prior to
scanning the barcodes and associating them with positions in the Toolbox.
Activating
1. Swipe your finger across the capacitive switch several times to wake the beacon out of shipping mode
into broadcast mode. The under surface LED light becomes solid and then turns off.
Figure 19 Activating Outdoor Style Beacon
2. Put the beacon in connect mode. Press your finger on the capacitive switch for about five seconds. The
under surface LED will flash slowly. Refer to the table below for information about operating modes and
LED blink patters.
NOTE: When installing numerous beacons, group beacons by category and activate them prior to
scanning the barcodes and associating them with positions in the Toolbox.