Installation Guide
Table Of Contents
- Terms of Use
- Contents
- About This Document
- Hardware Specifications and Installation
- Lozier® Shelves
- MB1000 Beacon: MPACT-T1B20-000-WR
- MB1000 Beacon: MPACT-T1B10-000-WR
- MPACT-MB2000-01-WR, MPACT-MB1000-01-WR, MPACT-MB2001-01-WR, MPACT-SB2000-01-WR
- USB Beacon: MPACT-MB3000-01-WR
- Beacon Part Numbers: MPACT-MB4000-01-WR and MPACT-MB4001-01-WR
- Beacon: MPACT-MB1000-01-WR and MPACT-SB1100-01-WR
- Fixed IoT Bridge (hub): MB5000-01-WR
- Mobile IoT Bridge (badge): MB6000-01-WR
- Cradle Charger: MPACT-MB6000-CHRGR
- Troubleshooting
3
Hardware Specifications
and Installation
Bluetooth Low Energy beacons from Zebra can be used with Zebra Location Solutions (MotionWorks and
MPact) or other third-party solutions.
Lozier® Shelves
Beacon brackets for the MPACT-T1B20-000-WR and MPACT-T1B10-000-WR are used with the following
Lozier products:
• TL Shelf
• DL Shelf
• HL Shelf
• Standard Base Deck
MB1000 Beacon: MPACT-T1B20-000-WR
As a prerequisite, the following hardware items are required to mount the tie-wrap style beacon housing to
a pole or similar structure:
• Beacon (tie-wrap style housing) part number MPACT-T1B20-000-WR
• Plastic tie wraps for attaching each beacon housing to the shelf
Mounting and Installing
Tie-wrap beacon housings are designed to attach to vertical or horizontal poles or similar mounting
surfaces. As shown in Figure 1, there are openings on the back of the beacon housing allowing a tie wrap
through the openings and wrapped around a pole or similar structure.
Notice the up arrow located on the middle of the beacon housing, this arrow indicates the optimal
orientation for the beacon to function properly. Additionally, the smooth front of the beacon should face
outward toward the aisle.
Figure 1 shows a beacon with the mylar strip attached to the left-hand side of the housing.