Owner's manual

2
11. Repeat Step 6 through Step 10 on the right side of the device.
12. Re-connect the PCB cable connector to the illumination PCB on both sides of the device.
13. Disengage the snap and remove camera opening plug.
14. Remove the clear plastic lens cover from the color camera and snap in camera housing into place.
15. The color camera cable has four connectors:
a. Connect the 3-pin connector on the longest branch to the User Interface PCB.
b. Connect one 3-pin connector to each illumination PCB.
c. Connect the 5-pin connector to the color camera.
16. Route the camera cable through guiding ribs 1, 2, and 3 and under the cable retainer tab.
17. Attach the USB cable and route it under the cable retainer tab, through guiding ribs 1 and 2 to the side of the device.
18. Install the new rear tower cover.
19. Attach the service label next to the manufacturing label under the platter.
20. Replace the platter.
3-Pin
Connector to
User
Interface PCB
3-Pin Connectors
5-pin Connector
into Camera
USB Connector
NOTE: The USB cable only connects correctly in one orientation. When connected upside down, the camera does not operate and
the cable interferes with the rear housing.
Portrait Camera
Landscape Camera
USB Cable
Cable Retainer
Tab
Cable Guiding Ribs (1, 2, 3)
USB Cable
Service Label Placement
Under Platter