Datasheet

AP-5131 Access Point Product Reference Guide
4-4
3. Refer to the Factory Defaults field to restore either a full or partial default configuration.
4. Use the Restart AP-5131 field to restart the AP (if necessary).
5. Click Apply to save any changes to the System Settings screen. Navigating away from the
screen without clicking the Apply button results in all changes to the screen being lost.
Serial Number Displays the AP-5131 Media Access Control (MAC) address.
The AP-5131 MAC address is hard coded at the factory and
cannot be modified. The LAN and WAN port MAC addresses
can be located within the LAN and WAN Stats screens. For
information on locating the AP-5131 MAC addresses, see
Viewing WAN Statistics on page 7-2 and Viewing LAN
Statistics on page 7-5.
Restore Default
Configuration
Select the Restore Default Configuration button to reset the
AP’s configuration to factory default settings. If selected, a
message displays warning the user the current configuration will
be lost if the default configuration is restored. Before using this
feature, Symbol recommends using the Config Import/Export
screen to export the current configuration for safekeeping, see
Importing/Exporting Configurations on page 4-30.
Restore Partial
Default Configuration
Select the Restore Partial Default Configuration button to
restore a default configuration with the exception of the current
LAN, WAN, SNMP settings and IP address used to launch the
browser. If selected, a message displays warning the user all
current configuration settings will be lost with the exception of
WAN and SNMP settings. Before using this feature, Symbol
recommends using the Config Import/Export screen to export the
current configuration for safekeeping, see Importing/Exporting
Configurations on page 4-30.
Restart
AP-5131
Click the Restart AP-5131 button to reboot the AP. Restarting the
AP-5131 resets all data collection values to zero. Symbol does not
recommend restarting the AP during significant system uptime or
data collection activities.
NOTE The Apply button is not needed for restoring the AP-5131 default
configuration or restarting the AP-5131.