Datasheet

Command Line Interface Reference 8-127
AP5131>admin(system.access)>set
Description:
Defines the permissions to access the AP-5131 applet, CLI, SNMP as well as defining their timeout values.
Syntax:
For information on configuring AP-5131 access settings using the applet (GUI), see Configuring Data Access on page 4-5.
set applet lan Defines the applet HTTP/HTTPS access parameters for the LAN port.
applet wan Defines the applet HTTP/HTTPS access parameters for the WAN port
app-timeout <minutes> Sets the radio interface timeout interval if no activity is detected over
Applet HTTPS (port 443) after the defined interval. Default is 300 Mins.
cli wan Defines CLI Telnet access parameters for the AP-5131 WAN port.
cli lan Defines CLI Telnet access parameters for the AP-5131 LAN port.
ssh wan Sets the WAN access to the CLI using the SSH (Secure Shell) protocol.
ssh lan Sets the LAN access to the CLI using the SSH (Secure Shell) protocol.
auth-timout <seconds> Disables the radio interface if no data activity is detected after the interval
defined. Default is 120 seconds.
inactive-
timeout
<minutes> Inactivity interval resulting in the AP terminating its connection.
Default is 120 minutes.
snmp wan Sets SNMP interface values through the WAN port.
snmp lan Sets SNMP interface values through the LAN port.
admin-auth local/
RADIUS
Designates a Radius server is used in the authentication verification.
server <ip> Specifies the IP address the Remote Dial-In User Service (RADIUS) server.
port <port#> Specifies the port on which the RADIUS server is listening. Default is 1812.
secret <pw> Defines the shared secret password for RADIUS server authentication.