Datasheet

Monitoring Statistics
7-3
2. Refer to the Information field to reference the following AP-5131 WAN data:
3. Refer to the Received field to reference data received over the AP-5131 WAN port.
Status The Status field displays Enabled if the WAN interface is enabled
on the WAN screen. If the WAN interface is disabled on the WAN
screen, the WAN Stats screen displays no connection information
and statistics. To enable the WAN connection, see Configuring
WAN Settings on page 5-13
HW Address The Media Access Control (MAC) address of the
AP-5131 WAN
port. The WAN port MAC address is hard coded at the factory and
cannot be changed.
IP Addresses The displayed Internet Protocol (IP) addresses for the
AP-5131
WAN port.
Mask The Mask field displays the subnet mask number for the
AP-5131’s WAN connection. This value is set on the WAN screen.
Refer to Configuring WAN Settings on page 5-13 to change the
subnet mask.
Link The Link field displays Up if the WAN connection is active
between the
AP-5131 and network, and Down if the WAN
connection is interrupted or lost. Use this information to assess the
current connection status of the WAN port.
Speed The WAN connection speed is displayed in Megabits per second
(Mbps), for example, 54Mbps. If the throughput speed is not
achieved, examine the number of transmit and receive errors, or
consider increasing the supported data rate. To change the data
rate of the 802.11a or 802.11b/g radio, see Configuring the 802.11a
or 802.11b/g Radio on page 5-38.
RX Packets RX packets are data packets received over the WAN port. The
displayed number is a cumulative total since the WAN interface
was last enabled or the
AP-5131 was last restarted.
RX Bytes RX bytes are bytes of information received over the WAN port. The
displayed number is a cumulative total since the WAN interface
was last enabled or the AP -5131 was last restarted. To restart the
AP-5131 to begin a new data collection, see Configuring System
Settings on page 4-2.