Specifications

Application Deployment 5 - 19
Disk Full TCM failed to create Hex image file at the selected path. Check available disk
space.
Target Disk Full Build process failed because TCM failed to add file to the image of a disk
volume. Remove some files or increase the disk size.
Hex file is READ ONLY The Hex image file to be created exists and is read-only. Delete the existing
file or change its attribute.
Error opening the file xxx with
write access
TCM could not open file xxx with write access. Check if file is in use.
Failure creating binary file TCM failed to open/create an intermediate binary file.
Hex File To load is missing or
invalid
In Load Terminal window, the file selected to load has invalid status.
Could not locate MK3000
name in TCM.ini file
While loading the Script Properties window, TCM could not find the TCM.ini
section corresponding to the MK3000 type specified by the current opening
script. Either TCM.ini or the script file is invalid.
Incorrect disk sizes in TCM.ini
file
The total disk size specified in the script does not match the total disk size
defined in the corresponding TCM.ini section. Check if the script is corrupt or
the TCM.ini has changed after the script was created.
INVALID DIRECTORY In Script Properties window, the selected System File Path is not a valid
directory.
One of the disk sizes is one
sector in size
In Script Properties window, one of the disks is too small (one sector in size).
This may cause problem while building images, especially when cushion is
enabled. Increase the disk size.
INVALID VOLUME NAME In Script Properties window, one of the volume labels is not valid.
Corrupt TCM.INI file! (Invalid
value of VolumeDivisor)
The VolumeDivisor entry is missing or invalid in the TCM.ini. Reinstall TCM or
recover TCM.ini.
Invalid version of TCM script
file
The TCM script was not created by this version of TCM.
Corrupt or missing TCM.ini
file
TCM could not find TCM.ini file.
FAILED CONNECTION TO
COM PORT (Could not get
status)
While downloading images to MK3000, TCM failed to connect to the selected
COM port. Check if the COM port is free and is properly configured.
FAILED CONNECTION TO
TERMINAL (Terminal Not
Connected Properly/Terminal
Not Ready to Receive)
While downloading images, TCM failed to connect to the MK3000. Check if
the correct flow control protocol is selected and the MK3000 is properly
connected and is in a listening state.
Table 5-3 TCM Error Messages (Continued)
Error Description/Solution