User`s manual

Setup Mode

980548-001 Rev. A KDU Plus User’s Manual 6/12/06

Operational Mode Selection

Selecting an Operational Mode will immediately enter the selected mode and store that setting

into the KDU Plus’s configuration memory. The KDU Plus has exited the Setup Mode.

Operational Modes interact with the Auto-Detect setting. If Auto-Detect is on (default

configuration), then making these settings will not continue after a power cycle. See

“Operational Modes” on page 11 for a diagram outlining Auto-Detect operation. We

recommend that the Auto-Detect feature remain on, ready for normal use in Forms Mode.

The KDU Plus will look at the stored Operational Mode setting if the Auto-Detect is off when

the printer and KDU Plus are first powered up. The KDU Plus will remain in this mode until

manually changed by the operator or the Auto-Detect his re-enabled (on) and the power is

cycled.

Keyboard Settings

The operator can control the sound and text editing method used by the KDU Plus.

KEY BEEPS - Turns off or on the beep (chirp) sounds for pressing on the keyboard keys. This

does not control the two attention beeps the KDU Plus makes when it is powered up and going

through a reset or when pressing the Esc (escape) key in Forms Mode.

EDIT MODE - Sets the data entry mode to over write (OVER) text at the displayed cursor

location or to insert (INSERT) text in the following character location without overwriting the

displayed data (text).