User`s manual

Setup Mode
14
980548-001 Rev. A KDU Plus User’s Manual 6/12/06
Changes made in Setup mode are stored in non-volatile flash memory. These settings remain
until the factory defaults are re-applied or they are changed again in Setup Mode. Turning off
the power does not change stored configuration settings (or stored files).
Entering Setup Mode
The operator can enter Setup mode immediately by pressing the Setup key when operating in
any of the other operational modes: Forms, Terminal and File modes. The Setup key is only
active in the initial screen in each of these modes. See Operational Modes on page 11 for a
basic description of the modes.
From here the operator can change the setting shown between the angle brackets ( > < ). Use
the up and down arrow keys to change your selection. Press the enter key to accept your
selection. Use the Esc (Escape) key to exit that setting or exit the Setup Mode.
Saving Setup Configuration Settings
You must completely exit the Setup Mode to save KDU Plus configuration changes. Do not
power down in setup mode or all changed settings will be discarded. The KDU Plus only
writes the changed settings to temporary memory prior to exiting Setup Mode. Writing
changes only once during the to flash (non-volatile) memory conserves the memory life.