User guide

1 - 10 MC31XX Series Mobile Computer User Guide
To remove the stylus, slide the stylus out of the stylus holder. To store the stylus, push the stylus back into the
stylus holder in the handstrap (MC31XXR/S) or stylus silo (MC3190G).
Starting the Mobile Computer
Press the Power button to turn on the mobile computer. If the mobile computer does not power on, perform a cold
boot. See Resetting the Mobile Computer on page 2-23.
When the mobile computer is powered on for the first time, it initializes. The Splash screen appears for a short
period of time, followed by the Calibration screen.
Figure 1-10 Splash Screen
On Windows CE 6.0 configurations, after the calibration procedure is performed the factory settings launch the
Sample Applications window displays. Application specific shells may provide application specific windows
instead of the Sample Applications window. These screens also appear when a cold boot is performed.
If the mobile computer does not power on, see Resetting the Mobile Computer on page 2-23.
Calibration Screen
Use the Calibration screen to align the touch screen:
1. Remove the stylus from the stylus holder.
2. Carefully press and briefly hold the stylus tip on the center of the Calibration screen target. Repeat the
procedure as the target moves and stops at different locations on the screen. This enters the new calibration
settings.
Figure 1-11 Calibration Screen
3. Once all of the new calibration settings are input, tap the screen or press the ENTER button to save the new
calibration settings. Press
ESC to discard the new calibration settings.