Quick Start Guide

MC2200/MC2700 Quick Start Guide
21
4-Slot Battery Charger
USB Cable
The USB cable plugs into the bottom of the device. When attached to the device the cable allows charging,
transferring data to a host computer, and connecting USB peripherals.
Scanning
The device offers the following data capture options:
• SE4710
Scanning with Internal Imager
To read a barcode, a scan-enabled app is required. The device contains the DataWedge app that allows the
user to enable the imager, decode the barcode data, and display the barcode content.
To scan with the internal imager:
1. Ensure that an app is open on the device and a text field is in focus (text cursor in text field).
2. Point the exit window on the top of the device at a barcode.
3. Press and hold the scan button.
The red laser aiming pattern turns on to assist in aiming.
NOTE: When the device is in Picklist mode, the imager does not decode the barcode until the crosshair or aiming dot touches
the barcode.
4. Ensure the barcode is within the area formed by the crosshairs in the aiming pattern. The aiming dot
increases visibility in bright lighting conditions.
Table 10 4-Slot Battery Charger Features
Number Item
1 Battery Slot
2 Battery Charging LED
3 Power LED
Table 11 USB Cable
Number Item
1 USB Slot
MN-00xxxx-01EN_mc2200-mc2700-qsg-en.fm Page 21 Monday, August 10, 2020 2:48 PM
Draft v4