Specifications

Introduction 1 - 7

4. Ensure that the black rubber pad in the battery compartment is lying flat along the bottom of the

compartment, with its smoother side facing up, and the rubber “fingers” straddling the screw boss.

5. Ensure the wire latch is in the up position.

6. Place the battery, rounded side down, in the compartment. Using a non-metallic tool (if necessary), guide

the battery cable connector into the female battery connector on the mobile computer.

Figure 1-6

Insert Battery

The connector is keyed so it only fits one way.

7. Press the connector down to ensure a positive connection.

8. Place wire latch down until just below top of the screw boss.

Figure 1-7

Close Wire Latch

9. Place the battery cover onto the handle and slide it as shown.

Wire Latch

Screw Boss